Isp-technologies THETA PRE AMP Manual de usuario Pagina 1

THETA FOOT CONTROLLER 1. PREAMP1 SWITCH This switch turns on and off PREAMP1 the CLEAN channel preamp on the THETA. 2. PREAMP1 LED When

THETA PRE-AMP SPECIFICATIONS Power: Bass Control /Preamp 1 and 2: Bass Control /Clean and Distort: Mid Sweep Frequency /Preamps: Mid Sweep F

WARRANTY AND SERVICE The Internal Circuitry is fully guaranteed to be free of defects under normal use and service for a period of

INTRODUCTION Congratulations on your purchase of the Theta stand alone pre-amplifier. You are now the owner of the most innovative guitar amplif

FRONT PANEL Understanding the THETA amplifier THETA PREAMP1 1. PREAMP1 ON LED This led indicates when PREAMP1 is active and in the s

4. MIDRANGE BOOST/CUT CONTROL This control works in conjunction with the SWEEP frequency control 5. The MID and SWEEP controls work to

THETA CLEAN CHANNEL 1. CLEAN CHANNEL ON LED This led indicates when the CLEAN CHANNEL is active. NOTE: The CHANNEL SELECT switch on the FOOTCONTR

SWEEP FREQUENCY CONTROL This control works in conjunction with the MID boost/cut control and adjusts the center frequency of the MID boost or cu

9. LEVEL CONTROL The LEVEL control adjusts the output LEVEL of the CLEAN channel. NOTE: The final output level is determined by the se

6. TREBLE CONTROL The TREBLE control adjusts the boost or cut that is applied in the high frequency portion of the spectrum of DISTORTION CHANNEL.

5. CHANNEL SELECT SWITCH The CHANNEL SELECT switch changes the THETA operating channel from CLEAN to DISTORT. The CHANNEL SELECT switch is a moment